Hatch-cover metal parts

Example image – not our fabrication Cover wheel with axle Wheels, axles and bushings of the cover. Workshop job Hinge eye and hinge pin

Example image – not our fabrication Hinge eye and hinge pin Hinges of folding covers between the panels. Clarify first Cleat / quick-acting cleat Cleats, cleat bodies, washers and wedges. Clarify first Compression bar and packing channel

Example image – not our fabrication Compression bar and packing channel Steel parts that hold and press the rubber seal. Clarify first Bearing pad, guide block, wedge

Example image – not our fabrication Bearing pad, guide block, wedge Pads on the coaming, locators and cross-joint wedges. Clarify first Drain channel and drain valve

Example image – not our fabrication Drain channel and drain valve Coaming drains and their non-return valves. Clarify first Other / not listed Describe it below and add a photo.

Clarify first

May be safety- or class-relevant: before the quote we clarify which requirements, documents and approvals apply. Depending on the ship and the use, this can include:

Drawing approval
Material certificates (EN 10204 3.1 / 3.2)
Welding procedure qualification (WPS / WPQR)
Welder qualification
Non-destructive testing (NDT)
Load test or strength calculation
Acceptance by the classification society

First assessment – the quotation is binding. The period for the quote starts once the requirements are clarified.

Please name the classification society and the place of installation below, and attach the original drawing if you have it.

Browse by ship area

Look something up

Sourcing desk

Top categories

Four groups, one case file

Get started

Get service

Supplier network

Plans

Technical guides

Maritime Signal

OceanSphere Additive

OceanForge

OceanSphere Fabrication

AI knowledge on board, offline

Where is the part used? *

Dimensions and design

Material and finish

Where and when

Your contact