Wear plate, slide pad or guide

Example image – not our fabrication Cargo-hold lining Tank top, hopper and frame protection against grabs. Workshop job Ramp and car-deck wear plate

Example image – not our fabrication Ramp and car-deck wear plate Hinge and landing plates of ro-ro ramps. Workshop job Chute and hopper liner

Example image – not our fabrication Chute and hopper liner Liners for bulk handling and self-unloaders. Workshop job Slide strip / guide rail UHMW-PE or bronze strips on guides and covers. Workshop job Fender sliding panel

Example image – not our fabrication Fender sliding panel Front panels and UHMW pads of fenders. Workshop job Anchor pocket and hawse wear plate

Example image – not our fabrication Anchor pocket and hawse wear plate Liners where anchor and chain grind. Workshop job Other / not listed Describe it below and add a photo.

Clarify first

May be safety- or class-relevant: before the quote we clarify which requirements, documents and approvals apply. Depending on the ship and the use, this can include:

Drawing approval
Material certificates (EN 10204 3.1 / 3.2)
Welding procedure qualification (WPS / WPQR)
Welder qualification
Non-destructive testing (NDT)
Load test or strength calculation
Acceptance by the classification society

First assessment – the quotation is binding. The period for the quote starts once the requirements are clarified.

Please name the classification society and the place of installation below, and attach the original drawing if you have it.

Browse by ship area

Look something up

Sourcing desk

Top categories

Four groups, one case file

Get started

Get service

Supplier network

Plans

Technical guides

Maritime Signal

OceanSphere Additive

OceanForge

OceanSphere Fabrication

AI knowledge on board, offline

Where is the part used? *

Dimensions and design

Material and finish

Where and when

Your contact